Viking Dishwasher Repair
Drainage, wash-arm and control faults on Viking panel-ready and stainless dishwashers, including leak tracing.
What people describe when they call
- There is standing water in the bottom of the tub at the end of every cycle
- Glasses come out with grit on them and the top rack is still soaking wet
- It stops mid-cycle, flashes a code for a moment, then quietly resets itself
- The detergent door never opens — the tablet is still sitting in it at the end
What the visit consists of
- Drain pump, check valve and hose loop tested before anything is condemned
- Wash-arm bearings and spray pattern inspected — the usual cause of grit on glassware
- Fill valve, float and turbidity sensor checked against the control board
- Panel-ready doors removed and reset on the original fixings, catalogued as they come off
Parts are quoted against your model and serial number — not a universal substitute that fails again in a year. If the honest answer is that the repair does not make sense, we will say so. The bands this work falls into are set out below.
Crews are out 8:00 am – 8:00 pm, seven days; the phone is answered 24/7.
Rate lines for a Kirkland repair
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
Each line below is a range, not a headline figure. The technician measures first, then agrees the exact price with you in writing — before any work starts and before a panel comes off.
- Igniter or burner assembly
- $170–$460
- Oven thermostat or heating element
- $210–$470
- Refrigeration fan or defrost system
- $290–$650
- Dishwasher pump or control
- $210–$430
- Control board or touch panel
- $450–$690
- Compressor or sealed-system repair
- $1,420–$3,330
For scale — a comparable Viking replacement, before installation, runs $6,530–$16,680. That is what a repair quote is really being measured against, and it is why most of these faults are worth putting right rather than replacing.
What people say afterwards
4.9 / 5718 reviews
Ours runs most days and had started leaving a film on everything. Not the heater circuit — a blocked spray tower and a worn seal. Glassware is clear again.
Vance R.
It kept stopping mid-cycle, flashing a code for a second, then quietly resetting. A chafed harness under the tub, not the control board. Two months on, no repeat.
Willa J.
A puddle appeared under the front edge every few days and we had been mopping it for a month. Split fill hose at the clamp, nothing worse behind it. Found in ten minutes and dealt with before he left.
Rhona D.
Tell us what it is doing.
Model number and a plain description of the symptom is enough to start. Calls placed before 11am in Kirkland usually get a same-day window. The visit is a $89 service call, credited in full against an approved repair.
Crews out 8:00 am – 8:00 pm, seven days · the phone is answered 24/7
